Tech tips and how to's
Moderators: notoptoy, garth, S Allen
- Talented Enthusiast
- Posts: 1841
- Joined: Sun Jan 27, 2013 9:43 am
- Location: Cumming, GA
Just a caution for those rebuilding R and H motors..be sure not to mix "Metric" (late) and "English"/USS 3/8 thread (Early) cams and sprockets as that will result in a VERY poor running engine. If you do, your cam timing will be off by ~1/2 tooth (technically 6 crank degrees) with will result in pretty pathetic performance. If you have an early cam, you must run a early sprocket. Late cam needs a late sprocket.
Thought you would want to know.. PM or email if you are not sure what you have//
The very finest parts for your 311!
- Site Admin
- Posts: 3957
- Joined: Thu Dec 05, 2002 4:57 pm
- Location: Knoxville, IA(Lake Redrock)Antioch, CA(Winter Months)
- Model: 1500/1600
- Year: Low Windshield-64-67.5
I ended up using a metric cam with a metric sprocket on my early SAE stroker motor build due to the difficulty of obtaining an early SAE cam sprocket and this very issue. I also opted to use a known good Japanese aftermarket timing chain instead of the Motor Power chain as it was an unknown brand and did not pass muster with Dave P with consultation from JT. I heard that early SAE sprockets may not be an issue going forward.
66 Stroker-Viper Blue Eventually
67 SRL311-00279-resto project
Stock '72 240Z-Blue
2002 Ford F250 7.3 Diesel 2WD Hauler
2008 Toyota FJ Cruiser
2009 Smart ForTwo Passion Coupe
2013 Fiat 500 Abarth
- Monthly Subscriber-Roadster Enthusiast
- Posts: 3338
- Joined: Mon Oct 02, 2006 7:03 pm
- Location: Lake Balboa (SFV) - CA
- Model: 1500/1600
- Year: High Windshield-68-70
I have already forgotten the details of your post, HOWEVER, I know that if ever I am doing something in that area, that there is a warning post about something about it.
Thank you for taking the time.
1970 1600 (Stroker) - TOAD SAN (Eliza)
1970 1600 (Stock) - As Yet Unnamed
Lake Balboa (SFV) , California
- Roadster Nut-Site Supporter
- Posts: 1008
- Joined: Fri Feb 13, 2015 8:08 pm
A big thanks to Jim for posting this warning. I had very recently assembled the motor to my '67 using the cam, lifters and pushrods from a 68 that I have. I could not remember for sure which sprocket I had used, but I got in contact with Jim for some help. Instead of installing the motor today I removed the timing cover and the sprocket was the metric one so I swapped it. This of course saved me from doing it in the car, and even worse what I would have gone through later to figure it out if Jim had not just out of the blue posted about it. A big thanks to Jim!
located in Chester NH
1967 1600 in restoration
2013 Arctic Cat F-1100 turbo
Ford F-350 6.0
Ford 9000 puller, Ford 960 puller, Ford 901show, Ford 971 worker, Oliver 70 waiting its turn