Had to Cut Rear Wheel Bearings

General topics.

Moderators: notoptoy, S Allen, Solex68, bmccarthy67

Steve_69
Roadster Fanatic
Posts: 78
Joined: Fri Sep 11, 2020 7:37 pm
Location: Knoxville, TN
Model: 1500/1600
Year: High Windshield-68-70

Had to Cut Rear Wheel Bearings

Post by Steve_69 »

This past weekend, I set out to get my rear wheel bearings pressed off of the axles. I went by several shops and no one wanted to take on the challenge. I went by a friend's house that had a press, but no fixtures that would work out. So, reluctantly, I had to cut off the collars, the outer race, the inner race VERY CARFULLY so as to not damage the bearing surfaces. I cut down close to the surface and then used a chisel to break them. The good news is I was successful. The bad news is I had to make another order from Dean for the collars and the grease catchers. Oh well, progress is being had! :D I had not considered the difficulty in pressing these off, but now I can clean and paint the brake backing plates. :)
User avatar
bakerjf
Site Supporter
Posts: 1365
Joined: Wed Sep 07, 2011 5:48 pm

Re: Had to Cut Rear Wheel Bearings

Post by bakerjf »

You actually did it the preferred way. Pressing them off is a no-no.
J. Baker
Lafayette, CA
'69 2000 (Solex)