Datsun Roadster Forum-311s.org

I have NO financial gain in this, it is all about facilitating our community in its efforts to keep our cars on the road and looking good....

I have a 67 roller with a porthole hardtop (missing rear window), it has a roll bar and all of the chassis pieces. (Free, but ask for a $50 donation...

I took 14 inch stainless accent rings off of my stock wheels. I like the look better. The rings are sitting in my garage but may look better on your...

A pair of seats for a roadster. Appears to be vintage 68 - 69. Came along with a 69' Roadster I purchased years ago. Have no use for them but hate to...

Free to a good home. Don't have the second visor rod, just what is pictured. Just cover shipping. Thanks.
John

From a 1966 1600 I have these used parts:

A master clyinder
Rear wheel cylinders
Front calipers
Thermostat housing and cap
Lower radiator air dam...

I wont need any of this stuff, so if you need it come get it.
Old random U20 header

This pic shows the only obvious damage other than being cut at...

My Company has produced some comprehensive torque charts. I have offered to sell laminated versions for $2.50 shipped. I will gladly e-mail a pdf...

Aloha all,

I just replaced these with the Koni Richard shocks. Anyone who would like these are welcome to pick up. They only have a few thousand...

Slowly trying to get rid of this stuff... I doubt these are worth money, but what do I know... get em before I change my mind

Located in Culver...

Hope I am asking this question in the right thread...

I was wondering if anyone out there can look at my car and inspect it (or maybe if you know of...

Relax, its not as good as it sounds.

Short block only.
Has spun rod bearing and scored cylinder on #4.
H20 crank, rods and .020 over pistons
Other...

free just pay shipping
T

Incomplete engine that came as a spare with my roadster. Has been on a shelf in garage for 20 years. Missing both manifolds, carbs, water pump,...