311s Suspension Grease Zerks



So where are those pesky grease zerk fittings? Regular greasing can save wear and tear on front end parts and save you money in the long run. Have you priced new ball joints lately? There are 20 of them in all. 21 if you have a 4 speed. 23 if you have them in your after market u-joints. Here you go:

  • Upper A-arm 2 per side
  • Lower A-arm 2 per side
  • Upper Ball Joint 1 per side
  • Lower Ball Joint 1 per side
  • Tie Rod Ends 6
  • Idler Arm Housing 1
  • Rear Handbrake linkage 1 (rear axel pivot)
  • On the 1600 models there is a zerk fitting on the speedo cable housing at the tranny
  • **Non-stock U-joint 2
    **NOTE:(Stock U-joints do not have zerk fittings)

    Again, a little preventive maintenance goes a long ways. Enjoy the ride.




    Copyright (c) 2001-2008 www.311s.org
    All Rights Reserved.

    Reproduction of material presented here is strictly prohibited without written permission.