49KB,
Here is a shot of the newly installed motor. I do not remember it being that tight of a fit when I pulled the old motor. Intalled new clutch and rebuilt five speed. I cannot wait to try it out.

41KB,
Here is another shot of the newly installed motor. The ZTherapy SUs look pretty good. I have enough experience with Zs, I am sure they will not be a problem to adjust.

78KB,
Yet one more shot of the motor. I do not plan on using the ITG air cleaner I had on the motor. It fits but does not leave any room for my after market windshield washer tank. I will probably go with single K & Ns.

48KB,
Here is a shot from the front drivers side. I am using Corbeau seats instead of the stock. They fit in nicely but take away from the clearance of the steering wheel. I fit and that is all that counts.

34KB,
Here is a shot from the rear with the bumper installed. I chose to leave the over riders off. I like the clean look much better than with them.

47KB,
Here is a shot of the Momo steering wheel. About all I have left to do is apply sound deadening material, carpet, interior panels, dash and gauges. I am patiently awaiting the arrival of composite dash face.

102KB,
Here is a shot of the newly installed dash and guages. The Momo steering wheel looks pretty good. One of the original problems I had with the car was blowing of fuses when you used the horn. Traced it down and found a short. Horn works great now.

87KB,
Here is another shot of the newly installed dash cover, face and gauges. They look great and everthing works. The Autometer gauges are much more dependable than the OEM gauges.

118KB,
Yet one more shot of the dash. I just finished up with the interior today. I bolted the roll bar in and the drivers side seat. Getting real close now.

110KB,
Here is a shot from the passengers side. Check out my oversize composite rear view mirror. My daughter gave that to me. Enough of the dash already.

91KB,
Here is a good shot of the Fairlady script on the passengers side.

77KB,
Here is another shot from the passengers side. I need to finish up the roll bar cover.