Datsun Roadster Forum-311s.org

I am having some commitment issues with permanently setting the SR20 in my frame. I set up a photo album showing where things are sitting on my third test fit:

http://pwp.att.net/p/PWP-brianstj

The biggest thing I am iffy on is the forward position. I have everything set up based (loosely) on the shifter position inside the car. I just don't know if I am going to run in to any big clearance problems if I am a little shifted to the front or back, and I have not been able to find any reference measurements. My pictures look pretty close to the "BOB" swap, but it is hard to tell how close I really am.

If anyone has any advise based on my pictures, or if anyone can give me a reference dimension for a sanity check (like the front pulley to front frame member) I would really appreciate it!

I will try to post some pics for you soon.
If you have not cut thr notch in the X member wait to see my pics.
I use the stock crossmember and mount no cutting of the X is involved.
PM me and we can exchange numbers email addresses and talk.
Kevin

Here are a couple of pics of the one i'm doing right now

a couple more

wow!
Those wheels look familiar

Hey Alvin
You have seen them before.
This is my dads car we are completly redoing it.
It should be ready for Solvang this year.
Kevin