Datsun Roadster Forum-311s.org

Posted: **Tue Sep 30, 2003 1:21 pm**

Hey guys...

Where did you guys go to replace that brass hose barb fitting that is attached tp on the water pump and intake manifold.

I need three of em to finish rebuilding the intake manifold brass fittings for the pre-heat water jacket.

The brass fitting is a 3/8 male thread end with a 5/8 pipe rubber hose bib end. The middle is hex nutted to bolt it in. It should be the same for both SU and Solex.

Thanks... I can only seen to find these things in steel locally.

Posted: **Tue Sep 30, 2003 1:27 pm**

Minh,

I found mine at NAPA.

Russell

Posted: **Tue Sep 30, 2003 3:06 pm**

Ok...

I looked everywhere but there... True Value, ACE, Lowe's, Home Depot, C&C Plumbing, Autozone, Kragen, and CarQuest...

I try and stop there this evening

Thanks Russell !

Posted: **Tue Sep 30, 2003 4:02 pm**

The originals were steel. Pep Boys and Advance Auto Parts carry a supply of them as well. Brass is a good idea. I am surprised that you could not find them at Home Depot or Lowes. I would have figured that they would have them....

Posted: **Tue Sep 30, 2003 6:25 pm**

Hey... Just trying to doit right!

BTW: Home Depot has the shiniest brass pipes and plugs...

Bling, Bling!!!

Posted: **Tue Oct 07, 2003 3:18 pm**

Steve, Sid...

Here is the part number from Napa for the parts interchange page.

Brass Fitting
Hose ID: 5/8
Male Pipe Thread: 3/8
Maker: Boston Weatherhead
Part Number: 05710B-106

Datsun Roadster Forum-311s.org

Brass hose fittings...

Brass hose fittings...