Page 1 of 1
VDO gauges - dont have a clue
Posted: Thu Jan 09, 2003 11:55 pm
by Guest
I have installed a VDO clock and it is working great. I would like to replace the water temp, install a voltmeter (ammeter is gone), fuel gauge, and oil pressure gauge with series 1VDO gauges. The speedo and tach were rebuilt by the PO and i would like to keep them. My problem is i have no idea on what is needed or how to pick the right sender etc. any info or what i need specifically would be great. I have a 67 1600 4 speed.
Thx,
Mike
RE:Gauges and fittings
Posted: Fri Jan 10, 2003 7:21 pm
by S Allen
Mike,
The fittings are a bit different from early to late. The early were standard thread and the later metric. I could have it bass ackwards but I believe this to be correct. Your car is a 67 right? Should be standard thread. Your best bet is to go to a hardware store and buy some fittings to test fit and then order the proper adapters from VDO. I am pretty sure the oil line is 1/4" NPT but I am not 100% positive on this. On my early cast iron head I tapped the mounting hole out to accept a 3/8" adapter for my Autometer temperature sensor. Worked out great and best of all no leaks. Actually all of the Autometer gauges came with several sizes of adapters but I still had to do a trial and fit for the temperature gauge. When you do figure it out-please let us know so I can document it on the site. Good luck.
Steve