Datsun Roadster Forum-311s.org

I'm looking for the o-ring seal on the 5-speed strike rod. The part number in the parts manual is 32845-18800, which shows to be NLA from Nissan. I don't need a full gasket set, so I am looking for dimensions on the o-ring so I can get one elsewhere. Anyone have the measurements?

Thanks in advance.

Peace, Pat

Oops, wrong part number, should have been 23858-14600, which Nissan shows to be a current part.

Peace, Pat

Habitat.pat wrote: Sun Feb 09, 2025 10:46 pm I'm looking for the o-ring seal on the 5-speed strike rod. The part number in the parts manual is 32845-18800, which shows to be NLA from Nissan. I don't need a full gasket set, so I am looking for dimensions on the o-ring so I can get one elsewhere. Anyone have the measurements?

Thanks in advance.

Peace, Pat

If you are referring to Part No 5 (o ring) I think you had it right the first time P/N 32845-18800, discontinued. I don't see P/N 23858-14600 coming up.

Correct page, item 10.

Habitat.pat wrote: Mon Feb 10, 2025 4:09 pm Correct page, item 10.

Gotcha, I think you may have also fat fingered in the wrong number. No, 10 is 32858-14600 , not 23858-14600. i do that daily

I see that some people made the correction on the part number. The reason I am responding is because the kit I used to rebuild my 4spd. had a lip seal instead of the o ring/cap setup. I think it was a Nissan gasket set, it was a long time ago. Trying to go thru my receipts, etc. to find more info. (same design as speedo.pinion seal, just sized for striking rod shaft). Wish I had more info at this time, might be able to find a usable lip seal that works.

Thanks for the responses, we found one at a dealer.

Peace, Pat