Need a photo of the weights in a stock distributor...

Post by **spl310** » Sun Feb 26, 2006 11:16 pm

I was stoopid and did not note how it all came apart. Which spring goes to which weight? How is the cam oriented?

shifty · Post by **shifty** » Mon Feb 27, 2006 1:17 pm

I thought I had a picture, but I can't find it.

I have a reference somewhere in the garage that I used to rebuild and recurve my dizzy. I will try and find it tonight.

Post by **spl310** » Mon Feb 27, 2006 4:28 pm

Thanks Leigh. I THINK I have it right, but it would help to verify...

shifty · Post by **shifty** » Mon Feb 27, 2006 9:16 pm

From Dann at Rallye's dizzy recurve instructions (10 typewritten pages, single spaced! It came in Zippy's pile of stuff in the trunk).

The weight hooked to the smaller spring goes in the smaller hole (the shorter slot). This also means that the flat part of the cam that the rotor mounts to faces the large spring.

Post by **spl310** » Mon Feb 27, 2006 9:23 pm

Outstanding! That is how I set mine up!! Thanks!!!