Datsun Roadster Forum-311s.org

I was given a 2000 (no motor) that looked good until I got it on the trailer. Unfortunately the frame and underneath are completely shot. I could not even get any of the front lug nuts loose after soaking in PB blaster for days, heat, and the highest torque 1/2" cordless impact Milwaukee. Lugs are so rusted to the rims that they would not snap.
Very disappointing. I was really excited about restomodding it.
Fortunately for someone the lights and trim are all there and in really good shape. I believe the hood and trunk lid are good. I am not sure what lurks under the paint of the fenders or doors.
I can put pics up if there is intrest.
Being a car guy I can't bring myself to dispose of the car with parts I know there is a need for.
I would send for cost of shipping and a bit of my time for dismantling and packaging etc.

When/ if the time comes. Would you consider selling the Shifter plate from the interior? It's the piece that the Shifter goes through and the shifting diagram playe is on it? The one I have on my 68 1600 was cut, PO used a tin snips by the look of it? To a much larger hole size for a Hurst Shifter boot around early 70s. Cuts into the boot fabric every shift.

Todd,

I could you the seat adjuster rails and hardware. let me know if they are available.

If you were closer I’d want it, I’m looking for a body