First Drive!!
Posted: Mon Feb 13, 2006 12:15 am
Got the car running well enough that I thought I would take it up & down the block.
Works GREAT!! Transmission shifts beautifully! Throttle is very "crisp" as is the exhaust note!
I still have a couple of bugs to work out.
- Oil leak that I thought was my VR sensor looks like it is actually the oil pan gasket, hopefully just a loose bolt or two (fresh rebuild).
- Tach reading doesn't seem quite right, but I could be wrong. Seems to climb too fast. Have to figure a way to check it.
- Speedo didn't work? I'm not sure where I went wrong on this one. ( Classic Instruments electronic gauges )
- Have to align the body so a tire doesn't rub the wheel wells.
- Can't seem to get the idle below about 1000 rpm. and it is rougher than I like but don't know if that is due to the 270* cam. Set the 1600 carb
nozzles to .093 (following the writeup on 311s.org) and balanced the air using a synchrometer. I was hoping for a relatively smooth idle at about 800 rpm.
Hopefully with another couple of sunny weekends I'll be able to get these things sorted and start driving it on a regular basis.
Details of the build as of today:
'66 1600
R16 block, G15 crank, 1600 rods, custom pistons (1800 cc ~9.2:1 compression).
Aluminum Head, ported, oversize valves.
Stock SU carbs, intake (so far - soon efi)
Megajolt Lite Jr / Ford EDIS ignition.
14" Electric fan.
'84 Datsun deisel p/u 5 spd bellhousing (modified).
'92 Nissan 240SX 5 spd, 5th changed to .833 (from .759:1)
Shortened driveshaft.
Thanks to Steve for the 311 site, and all those here that have answered my questions and put up with my tirades.
Cheers
Works GREAT!! Transmission shifts beautifully! Throttle is very "crisp" as is the exhaust note!
I still have a couple of bugs to work out.
- Oil leak that I thought was my VR sensor looks like it is actually the oil pan gasket, hopefully just a loose bolt or two (fresh rebuild).
- Tach reading doesn't seem quite right, but I could be wrong. Seems to climb too fast. Have to figure a way to check it.
- Speedo didn't work? I'm not sure where I went wrong on this one. ( Classic Instruments electronic gauges )
- Have to align the body so a tire doesn't rub the wheel wells.
- Can't seem to get the idle below about 1000 rpm. and it is rougher than I like but don't know if that is due to the 270* cam. Set the 1600 carb
nozzles to .093 (following the writeup on 311s.org) and balanced the air using a synchrometer. I was hoping for a relatively smooth idle at about 800 rpm.
Hopefully with another couple of sunny weekends I'll be able to get these things sorted and start driving it on a regular basis.
Details of the build as of today:
'66 1600
R16 block, G15 crank, 1600 rods, custom pistons (1800 cc ~9.2:1 compression).
Aluminum Head, ported, oversize valves.
Stock SU carbs, intake (so far - soon efi)
Megajolt Lite Jr / Ford EDIS ignition.
14" Electric fan.
'84 Datsun deisel p/u 5 spd bellhousing (modified).
'92 Nissan 240SX 5 spd, 5th changed to .833 (from .759:1)
Shortened driveshaft.
Thanks to Steve for the 311 site, and all those here that have answered my questions and put up with my tirades.
Cheers