Page 1 of 1
1.6L flywheel bolts
Posted: Sun Jul 10, 2022 9:33 am
by Habitat.pat
I was all set up with flywheel to crank bolts for my stroker using a 2L crank until the crank was damaged. I now have a H20 crank to use but the bolts are different, matching the 1.6L bolts. I’d like to install new bolts but don’t find any from our vendors & there are no markings on them for hardness. Anyone know where I can get some or at least what I need to find? Haven’t checked the dealer yet but will tomorrow.
Peace,
Pat
Re: 1.6L flywheel bolts
Posted: Sun Jul 10, 2022 10:03 am
by Bwk2000
Not sure where to source them, but here are the bolt factory specs based on engine production number for the R16:
897215F3-F05E-423E-8AFB-9D65AE23A156.jpeg
Re: 1.6L flywheel bolts
Posted: Sun Jul 10, 2022 10:11 am
by SOUPY
Let me look...think I have a set
Re: 1.6L flywheel bolts
Posted: Sun Jul 10, 2022 10:26 am
by SOUPY
Easy find! Still on the engine. Used bolts with locking tabs.... Free plus shipping
Re: 1.6L flywheel bolts
Posted: Sun Jul 10, 2022 11:34 am
by Habitat.pat
Soupy, I have 2 sets on hand but I was hoping to replace them with new. Thanks for the offer though.
Peace,
Pat
Re: 1.6L flywheel bolts
Posted: Sun Jul 10, 2022 12:00 pm
by Bwk2000
Pat: Grade 8 bolts should work just fine. Used them on jeeps/trucks in the past without issue.
Re: 1.6L flywheel bolts
Posted: Sun Jul 10, 2022 1:26 pm
by 23yrRebuild
JT has ARP bolts for the flywheel to crankshaft. I ordered them, along with the 10 lb. flywheel / 225mm clutch for my stroker...
Re: 1.6L flywheel bolts
Posted: Sun Jul 10, 2022 5:31 pm
by Habitat.pat
Thanks, Mike I’ll check w/him.
Peace,
Pat