Page 1 of 1
Alternator bracket 67.5 1600 with H20 block
Posted: Mon Jun 13, 2022 4:46 pm
by Cjblzn
Looking to see how others with a H20 block mounted their alternator bracket, mine was apparently welded by previous owner and the bracket broke at the weld.
943E7352-86A3-4FF6-8F8B-E7198D9292E4.jpeg
18166F10-BD7B-4231-B171-4957AC3A43CD.jpeg
4FD479A6-9185-4DF4-893D-B01FB4D22D87.jpeg
re weld or another solution? Thanks
Re: Alternator bracket 67.5 1600 with H20 block
Posted: Mon Jun 13, 2022 10:05 pm
by notoptoy
I used a stock bar, and bent it to allow it to bolt on to the front of the head, below the thermostat tower I believe. I may have had to drill a hole, or widen the hole to accommodate the bolt. I will try to get a picture for you tomorrow, it was not very complicated though.
Re: Alternator bracket 67.5 1600 with H20 block
Posted: Tue Jun 14, 2022 7:45 am
by spl310
Post pictures that show the thermostat housing.
Re: Alternator bracket 67.5 1600 with H20 block
Posted: Tue Jun 14, 2022 1:18 pm
by Cjblzn
67E13B5C-B8E7-4ACE-8675-26D070F1121A.jpeg
910D7BE9-4174-4532-990E-FC60E3658483.jpeg
68A19458-52AE-48FF-851E-97CCCA254FA4.jpeg
Re: Alternator bracket 67.5 1600 with H20 block
Posted: Tue Jun 14, 2022 1:46 pm
by notoptoy
Took some pictures, I used the stock bracket, I think, at least it is one I had laying around if not the stock. I bolted it at the water pump. It involved a slight bend (it was flat and curved). In addition I used a grinder and "notched: the bracket to clear the head. Works a charm and doesn't seem to be showing any signs of fatigue.