Need a dimension...

Post by **spl310** » Wed Jan 18, 2006 10:33 pm

Can anyone give me some dimensions? I need the dimensions of the carb spacers for a 1600. Specifically, the center bore diameter in MM, the bolt hole spacing and the thickness. I would measure some, but don't have any renegades lying around...

Thanks!

Import_sounds-of-mid-GA · Wed Jan 18, 2006 10:35 pm

are they the same as 2000 SUs? I might take mine off to clean the manifold and header.... can you wait?

Post by **itsa68** » Wed Jan 18, 2006 10:52 pm

Here you go:

Bore 39.37 mm
8.76 mm diameter holes spaced center to center at 75.946 mm
Thickness 14.350 mm
Outside length 98.05 mm
Outside width 57.10 mm

Eric F · Post by **Eric F** » Wed Jan 18, 2006 10:52 pm

Sorry, 2000s aren't quite the same. Sid, I have some at home and will measure them in 2 hours.

Eric

WOW! He's fast! WE posted the the same time!

Post by **spl310** » Wed Jan 18, 2006 11:01 pm

Thanks!! I may have to round some of those up to see if I can make them work on this project I have...