On an R16, assuming SAE version as other internals have been confirmed as SAE on this motor, can anyone provide what the thread pitch is for the port that the Temp Gauge sending unit assy threads into? This would be once everything is removed and just the hole in the head is left.
What is that thread size?
Seeking to make or buy over the counter brass fitting to mate 1/2" NPT to thread into the head.
Thanks
Seeking Thread Size for Temp Sending Location Port on R16
Moderators: notoptoy, S Allen, Solex68
-
- Roadster Fanatic
- Posts: 244
- Joined: Mon Jun 20, 2011 11:51 pm
- Location: SoCal
- Habitat.pat
- Roadsteraholic
- Posts: 601
- Joined: Thu Jul 07, 2016 8:29 pm
- Location: Central Texas
- Model: 1500/1600
- Year: Low Windshield-64-67.5
Re: Seeking Thread Size for Temp Sending Location Port on R16
I don’t know the thread but I recall that is a straight thread that bottoms out in the bevel-bottomed hole to seal the sensor against the head.
I have a new sender & nut but they are metric.
Peace,
Pat
I have a new sender & nut but they are metric.
Peace,
Pat
67.5 SPL311 Stroker Restomod
Pat Horne, Near Austin, TX
We support Habitat for Humanity
A hand UP, not a hand OUT
Pat Horne, Near Austin, TX
We support Habitat for Humanity
A hand UP, not a hand OUT
-
- Roadster Nut
- Posts: 52
- Joined: Tue Feb 01, 2022 1:31 am
- Location: Gilroy ca
- Model: 1500/1600
- Year: High Windshield-68-70
Re: Seeking Thread Size for Temp Sending Location Port on R16
Mine was m16x 1.5 on my 1969 1600. Glowshift has an adapter.