Hood Bumper Install

[bossbob]

What's the best way to install the little rubber points into the body of the car for the hood bumpers.
Thanks,

[nismou20]

Lube and push/twist back forth. A small point awl also helps to coax it in.

[Nissanman]

Ordinary dish washing liquid is a good lube for installing rubbery bits

[dynaguy]

I sharpened a 1/4" wooden dowel in a pencil sharpener, used di-electric silicone grease as lube. Poked the lubed rubber tip in with the dowel while twisting it into place. The dowel wont scratch the paint when it slips off. Pat

[bossbob]

Thanks again, you guys make this too easy.

[bikermike]

I pulled on the rubber nub from below with needle nose pliers.

http://www.311s.org/phpBB3/viewtopic.ph ... ood+rubber

[Curtis]

I used Goop water less hand cleaner and lots of swearing, at least on one of them.

[higgins67]

I scored them around their base with a steak knife to form more of a rivet shape. Did the trick.

[redroadster]

I always smash one with a hammer ...and let the others see it ....they go it pretty easy then