Page 1 of 1
Timing on my 1600
Posted: Sun Mar 27, 2022 3:17 pm
by GarageGuy
So, I have a timing light on the old girl. But my distributor adjustment only gets me close to the marks on the pulley before I run out of adjustment. Can it be 180 out ? It's in the same position it was in, vac advance toward the fire wall. It only went all the way in one way. If you know what I mean.
HELP !
Re: Timing on my 1600
Posted: Sun Mar 27, 2022 3:48 pm
by GarageGuy
Drove it around the block. Zero power.
Re: Timing on my 1600
Posted: Sun Mar 27, 2022 3:53 pm
by GarageGuy
Forgot to unhook vac advance.
Re: Timing on my 1600
Posted: Sun Mar 27, 2022 6:32 pm
by notoptoy
Hope that got you what you needed for timing, otherwise, you may have to move your timing gear (In the base of the distributor tower) one tooth in order to add to your range of adjustment.
Re: Timing on my 1600
Posted: Sun Mar 27, 2022 7:22 pm
by GarageGuy
I was guessing that. I will look into that. Thanks for the advice
Re: Timing on my 1600
Posted: Sun Mar 27, 2022 7:26 pm
by Nissanman
Don't forget that there is another adjustment at the backside of the distributor base.
What I do is set up the lower adjustment to give TDC spark with the upper adjustment pointer at "0".
Then you can make use of the engraved graduations on the upper plate to indicate actual timing BTDC.
Re: Timing on my 1600
Posted: Sun Mar 27, 2022 8:47 pm
by redroadster
High dome pistons ? 12 to 1 ?
be sure you have 98 octane in it ...right
Not available , 91-93 here ...so retard it a bit
Re: Timing on my 1600
Posted: Mon Mar 28, 2022 9:28 pm
by GarageGuy
YOU GUYS ARE LIFE SAVERS !
I DO HAVE THE GOOD GAS IN IT. THANKS GUYS
Re: Timing on my 1600
Posted: Sat Jun 10, 2023 12:17 pm
by GarageGuy
Had two plug wires switched for a year. Got that fixed. Coil went out. Got that fixed. The little car has good power.
Been a rocky road getting here.
HELP !