Page 1 of 1
Wiper motor
Posted: Sun Feb 20, 2022 3:14 pm
by johnscf
I’m cleaning up my wiper motor and trying to get it to work again. Both wires going into what I think is the timing mechanism were out so I’ve taken the small cap off to solder them back in place. Does anyone know how to put the cap back on in the correct position so the stop and return point is correct without just trial and error?
Re: Wiper motor
Posted: Sun Feb 20, 2022 3:55 pm
by DAC21
johnscf wrote: Sun Feb 20, 2022 3:14 pm
I’m cleaning up my wiper motor and trying to get it to work again. Both wires going into what I think is the timing mechanism were out so I’ve taken the small cap off to solder them back in place. Does anyone know how to put the cap back on in the correct position so the stop and return point is correct without just trial and error?
Curtis has been there done that, you might hit him up.