Datsun Roadster Forum-311s.org

Thinking about getting the Big Brake Package from Silvermine Motors for my '69 Roadster, but these require a 16-inch wheel. Anyone seen or can recommend a 16-inch wheel and tire combo? Thanks.
Steve

For my ‘69 with 280ZX 6.5”x14” rims, the biggest tires I can fit under the rear fenders are 195/60R-14s. With that stock fender restriction, if you are planning to run 16”s, I think your going to be limited to 195/45-R16s. You might be able to get 205/45R-16s to fit, but they are a bit wider and might rub on cornering - There isn’t a lot of free room there. All this depends on the width and offset of whatever 16” rims you decide on of course. Finding 16” rims in a 4x114.3” with CB 73.1mm might be a bit interesting though.

Maybe someone here who has run 16”s can provide some better insight into the combos available

Our big brake kits require a 15" wheel, and fit most common roadster wheels.

http://spriso.com/our-products/datsun-r ... rake-kits/



As for 16" tires, we typically run a 205/45/16, though my personal car has a 225/40/16 tire (with a shortened RX-7 rear axle)

Hey
Nice picture LOL.

SLW4491 wrote: Fri Dec 17, 2021 6:43 pm Thinking about getting the Big Brake Package from Silvermine Motors for my '69 Roadster, but these require a 16-inch wheel. Anyone seen or can recommend a 16-inch wheel and tire combo? Thanks.
Steve

Start by taking the time to look at this post

viewtopic.php?t=5787

All the wheel and tire info you need is in there including proper tire sizes

I want to upgrade my 64 roadster with the big brake kit. However, being that the 64 are drum brakes, will the big brake kit work? Can I use the drum rotor hub?

If the set up works, I am guessing that the 15” rims will work just fine as well.

Finally, if this works, I would like the swap out my springs like I did with my 1970 and give it a little lowered front end. Will the clearance work with the 64? Again, I am guessing it should work. Can anyone confirm?

Thanks,

Ed