Had to Cut Rear Wheel Bearings
Posted: Tue Nov 23, 2021 8:27 pm
This past weekend, I set out to get my rear wheel bearings pressed off of the axles. I went by several shops and no one wanted to take on the challenge. I went by a friend's house that had a press, but no fixtures that would work out. So, reluctantly, I had to cut off the collars, the outer race, the inner race VERY CARFULLY so as to not damage the bearing surfaces. I cut down close to the surface and then used a chisel to break them. The good news is I was successful. The bad news is I had to make another order from Dean for the collars and the grease catchers. Oh well, progress is being had! 
I had not considered the difficulty in pressing these off, but now I can clean and paint the brake backing plates. 
I had not considered the difficulty in pressing these off, but now I can clean and paint the brake backing plates.