Rear axle end play
Posted: Sat Sep 18, 2021 3:11 pm
I purchased new wheel bearings from one of our vendors & had them installed on my 67.5 axles & reinstalled the axles. I measured for shim pack thickness & didn’t need any. After installing the axles I checked end play & found 0.015†play on one side & 0.050†on the other. 0.050 seems to be way too much. Any thoughts/ideas?
Other than that the car is coming along well. Interior is almost complete, which just leaves the engine compartment, windshield & wheels. Block & crank are due in a week or two.
Peace,
Pat
Other than that the car is coming along well. Interior is almost complete, which just leaves the engine compartment, windshield & wheels. Block & crank are due in a week or two.
Peace,
Pat