Page 1 of 1
Did ‘67 and/or ‘67.5 Roadsters Come with Seatbelts?
Posted: Fri Jul 16, 2021 11:56 pm
by SP3
Looking to install a new set of lap belts and I am not finding pre-existing holes for the seatbelt fastening hardware on either side floor pan.
Is this something that has to be added? I can’t image PO would weld up the holes.
Any guidance would be appreciated before I attempt to drill extra holes in the car.
Thanks
Re: Did ‘67 and/or ‘67.5 Roadsters Come with Seatbelts?
Posted: Sat Jul 17, 2021 12:11 am
by Pjackb
SP3 wrote: Fri Jul 16, 2021 11:56 pm
Looking to install a new set of lap belts and I am not finding pre-existing holes for the seatbelt fastening hardware on either side floor pan.
Is this something that has to be added? I can’t image PO would weld up the holes.
Any guidance would be appreciated before I attempt to drill extra holes in the car.
Thanks
Both years the same
1 captive nut on the tunnel where it tappers , the other on the floor towards the back on the angled sheetmetal
7/16-20 if I remember correct
Re: Did ‘67 and/or ‘67.5 Roadsters Come with Seatbelts?
Posted: Sat Jul 17, 2021 1:01 am
by SP3
Thanks. So all the mounting points have captive nuts? Are they on the exterior side of floor pan or inside car?
I don’t recall seeing but am familiar with it on ‘69 models.