Page 1 of 1
Clutch bitting point
Posted: Wed Oct 14, 2020 7:17 pm
by joe fremeau
Hi All, finally ready to get the car in on the road. The problem is the biting point is high, is there any way of adjusting this ? The clutch is new so is slave, I believe clutch master is from a 510 if I remember right Thanks Joe
Re: Clutch bitting point
Posted: Wed Oct 14, 2020 9:41 pm
by notoptoy
Yes, you can adjust the height of the clutch pedal engagement at the slave cylinder on the passenger side of the transmission. I believe it moved the engagement point lower as you "tighten" the bolt (spin clockwise), but it might be just the opposite. Loosen the jam nut and move the adjustment nut a little bit, test it to see where you like it, and when done, retighten the jam nut.
Re: Clutch bitting point
Posted: Thu Oct 15, 2020 10:20 am
by MattC
Yep, just did this a few weeks ago...careful...a little adjustment seems to make a big difference (at least to me).