Page 1 of 1
Low windshield post rubber
Posted: Thu Jun 06, 2019 12:37 am
by SABLT194
My rubber pieces wont stay attached to the vertical post on my 66. Is there something I am missing on how these are supposed to be attached? I just have them clipped on into the small channel.
Regards,
Steve
Re: Low windshield post rubber
Posted: Thu Jun 06, 2019 1:57 am
by Nissanman
Those fellas [36] are supposed to be bonded to the stainless trim [17,18 & 12,13] which is riveted to the end of the windshield frame: -
Re: Low windshield post rubber
Posted: Thu Jun 06, 2019 4:55 am
by SABLT194
AHHHHHHHH! That's the only thing that makes any sense. I had removed the rivets and channels to have my posts re chromed years ago and cleaned up the stainless so I lost that little piece of information.
Thanks so much. Weatherstrip glue it is then.
Regards,
Steve
Re: Low windshield post rubber
Posted: Sat Jun 08, 2019 3:30 pm
by C.Costine
Nissanman wrote: ↑Thu Jun 06, 2019 1:57 am
Those fellas [36] are supposed to be bonded to the stainless trim [17,18 & 12,13] which is riveted to the end of the windshield frame: -
What is best to use to "bond" them? Last time I used contact cement but I wasn't happy with that. I recently picked up a tube of 3M Super Black Weatherstrip adhesive.
Re: Low windshield post rubber
Posted: Sat Jun 08, 2019 4:10 pm
by SABLT194
That's what I was fix'n to use
Regards,
Steve
Re: Low windshield post rubber
Posted: Sat Jun 08, 2019 6:44 pm
by devo
I used the 3M Super Black on mine over 2 years ago. No problems.
Re: Low windshield post rubber
Posted: Sat Jun 08, 2019 7:30 pm
by Nissanman
For a lot of the rubber I used a Polyurethane adhesive/sealant.
A bit pricey but sticks like baby do do's to a blanket.