Dist. recurve questions
Posted: Sat Apr 13, 2019 4:49 pm
So I bought a recurve kits and found some differences causing me questions. 1st is the breaker plate; the new one doesn't have the adjustment cam on it for adjusting the point gap. I am using a pertronix that doesn't seem to be able to be adjusted anyway so no problem unless I have to go back to the points for some reason.
2nd is the length of the slot in the new cam. The long slot in the new cam is only about 2/3rds the length of the old one. Not sure if this could possibly cause problems or not. I am hoping some of you more smarter than me gurus can tell me if all is OK or not.
The old weights and springs were pretty much worn out and the breaker plate was pretty clunky when it moved is the reason I decided to replace everything. Thanks in advance for your comments.
2nd is the length of the slot in the new cam. The long slot in the new cam is only about 2/3rds the length of the old one. Not sure if this could possibly cause problems or not. I am hoping some of you more smarter than me gurus can tell me if all is OK or not.
The old weights and springs were pretty much worn out and the breaker plate was pretty clunky when it moved is the reason I decided to replace everything. Thanks in advance for your comments.