Page 1 of 1
R16 Engine Rebuild Parts (Stroker)
Posted: Tue Mar 12, 2019 6:04 pm
by Sammy66
Hi, I have an R16 5-main engine that I would like to rebuild as a Stroker using H20 parts (to save money). I have seen the parts list provided on this site but wanted to know if anyone has a H20 parts supplier that they would recommend? I have seen forklift parts suppliers that sell complete engine rebuild kits but have no idea if they are reputable or who actually manufactures these parts?
Re: R16 Engine Rebuild Parts (Stroker)
Posted: Fri Mar 15, 2019 6:02 pm
by S Allen
Surprised no one has answered you as yet. Motor Power was the go to for H20 parts. They were bought out by another company. I have recently ordered parts from them and got the same great prices and service. You can still get to the Motor Power Inc website.
Motor Power Inc
Here is my previous discussion regarding the new ownership.
Previous Motor Power Inc Discussion
Steve
Re: R16 Engine Rebuild Parts (Stroker)
Posted: Sun Mar 17, 2019 10:57 am
by Sammy66
Hi Steve, I really appreciate your input! Thanks so much and I am looking forward to this project! Steve, is that H20 parts list the p/n list I should go off? Once again, thanks!
Re: R16 Engine Rebuild Parts (Stroker)
Posted: Sun Mar 17, 2019 12:09 pm
by Pjackb
Hey Sammy have you seen this post?
viewtopic.php?f=6&t=31547
Lots of good stuff to get you started on the stroker , especially the crank
Re: R16 Engine Rebuild Parts (Stroker)
Posted: Sun Mar 17, 2019 12:49 pm
by Sammy66
Thanks!
Re: R16 Engine Rebuild Parts (Stroker)
Posted: Sun Mar 17, 2019 10:08 pm
by vinechoy
I'm sure you know H2O and not H2O-2
Re: R16 Engine Rebuild Parts (Stroker)
Posted: Mon Mar 18, 2019 7:14 pm
by Sammy66
Yes.
Re: R16 Engine Rebuild Parts (Stroker)
Posted: Mon Mar 18, 2019 9:29 pm
by S Allen
Not sure what part numbers you are referring to. You should be able to order H20 parts for your stroker. There is a way not to have the 5 main crank cut as I and others have done. I believe Bill Cole used a spacer to make things work without cutting. Sure seems like the way to go. Maybe he will chime in.
Steve