Datsun Roadster Forum-311s.org

Hi,

I am rebuilding my car and lost the screws/ bolts for the front and rear lights. Does anyone have a resource or link to show me what size bolts and screws go where?

1966 Roadster with 2l engine

Not 100% sure what you are asking for but....

The headlight buckets are fastened to the fenders with 3/16 x 24 bolts.
The parking lights use 3/16 x 24 nuts.
The rear lights I have use M6 x 1.0 nuts.

S

Awesome, thanks. Is there a one-stop shop to tell me about every nut and bolt in the car?

In the wiki I believe there’s a list of all the screws nuts and bolts.

The wiki has pretty much all of the frame nuts and bolts listed. And-there may be a list of interior fasteners but I do not recall a list of every nut and bolt you would need to reassemble a complete car. I just happened to have those bits lying about and was able to check the thread sizes. There are slight differences between early low windshield and later high windshield fasteners.

S

Thank you all, very helpful

http://www.311s.org/pmwiki-311/pmwiki.p ... mFasteners

here ya go

Pat