Datsun Roadster Forum-311s.org

Hi all
Has anyone replaced the interior windshield pads.. ( 3 padded sections around the windscreen). Tips on install? What adhesive did you use?
68,2000.

Weldwood Contact Adhesive.

Also use a whole pile of clothes pins/pegs to hold edges.

yes indead, I used a whole lot of clamps of differing shapes and sizes. turned out looking awesome

yes indead, I used a whole lot of clamps of differing shapes and sizes. turned out looking awesome

Windshield trim complete

Windshield trim complete

Anyone else notice an echo?

Say what? Say what? Say what?

Looks nice! I need to do mine soon

thank you guys! really appreciated your comments. maybe i'm worry too much about windshield replacement. but from when i read, i don't see safelite mention rubber dam during the replacement, when i look up honda part, there are rubber dams in the diagram, do they skip this part?

hey , I thought that the inner rubber was all in one with the outer ?? am I misunderstanding this ? I planned on popping.my windshield one day , have the molding for our windshield (I hope ) do I need more.

I have my three piece all cut and ready to glue in. The driver side is flush against the window frame but the passenger side has a gap. I was thinking of using a heat gun to make it fit tight but don't want to melt the plastic. If we have a choice, what comes first, the trim or the windshield?

redroadster68 wrote: ↑Tue Dec 18, 2018 2:00 pm IMG_6465.PNGyes indead, I used a whole lot of clamps of differing shapes and sizes. turned out looking awesome

I see you did not tuck the trim under the windshield weatherstrip. Did it stay this way?

redroadster68 wrote: ↑Tue Dec 18, 2018 2:00 pm IMG_6465.PNGyes indead, I used a whole lot of clamps of differing shapes and sizes. turned out looking awesome

I see you did not tuck the trim under the windshield weatherstrip. Did it stay this way?