Wing Nut Remover/Installer Mod

[mraitch]

As MANY of us (especially Lorna C. - G) have experienced, getting to those pesky wingnuts behind the gauges can be a PITA. (whether the dash is in OR out of the car)

[attachment=1]20180327_200638[1].jpg[/attachment]
This 'tip' involves cutting a groove in a bolt of suitable length that will allow the wingnut 'wings' to be captured in the groove.
#1
[attachment=2]20180327_200658[1].jpg[/attachment]
Additionally, you have to use a drill bit, smaller than the diameter of the nut to drill a small hole so that the 'crown' of the nut will fit into it. #2
#2[attachment=2]20180327_200658[1].jpg[/attachment]

Wing nut 'embraced' by bolt

[greydog]

Very clever Peter.
Now, if you'd just invent an arm with 3 elpows and u limited wrist rotation I could get in there to reach the darn things.
Dan

[fj20spl311]

interesting, I think a tube would be less work.....cut the slots and a hole for a cross shaft and your done.

[mraitch]

Tube certainly MIGHT, if one had a tube with id of 1/2 inch lying around - this one didn't.

Plus one could use a socket on this - if one were so inclined, one was.