4 Sp Cluster gear thrust washers
Posted: Mon Mar 26, 2018 11:12 am
I have a question on the thrust washers for the cluster gear assembly in a servo style 4 speed transmission. The thrust washers have a notch stamped into them which I understand fits into a groove in the trans case and then keeps the washer from turning. Opposite the notch, the washer has an oblong cutout where the shaft goes through (purpose to drain oil?).
Does anyone know for sure the correct orientation of the notch/cutout?
When I took my tranny apart I missed noticing how they were oriented.
In looking at the unit it would seem to me the notch is up at the top, with the cutout towards the bottom, but I would really like to know for sure before closing everything up and re-installing it.
Thanks.
Does anyone know for sure the correct orientation of the notch/cutout?
When I took my tranny apart I missed noticing how they were oriented.
In looking at the unit it would seem to me the notch is up at the top, with the cutout towards the bottom, but I would really like to know for sure before closing everything up and re-installing it.
Thanks.