Re: The Quick/Small/(Stupid?) Question Thread-take 2
Posted: Tue Nov 14, 2017 9:27 am
Most of the cars that I have seen have had extra holes drilled.
They fit like they're supposed to down here in Texas. Just saying
Keith
Datsun Roadster Forum-311s.org
The Resource For All Things Datsun Roadster S211/SPL212/310/311 Datsun Sports Roadster 1959-April 1970 circa 40,000 produced
https://www.311s.org/phpBB3/
The Quick/Small/(Stupid?) Question Thread-take 2
Page 10 of 99
Re: The Quick/Small/(Stupid?) Question Thread-take 2
Posted: Tue Nov 14, 2017 5:35 pm
Re: The Quick/Small/(Stupid?) Question Thread-take 2
Posted: Tue Nov 14, 2017 7:39 pm
lol what better prisoners ?cktrap wrote:They fit like they're supposed to down here in Texas. Just saying
Keith
Re: The Quick/Small/(Stupid?) Question Thread-take 2
Posted: Tue Nov 14, 2017 10:18 pm
anyone seen these on eBay yet ? vrhat resto one that's first pic , is only needing paint left it seems .idk though.5k if it runs ? shoot.
Re: The Quick/Small/(Stupid?) Question Thread-take 2
Posted: Tue Nov 14, 2017 10:20 pm
i meant the red one is 5k only needs paint on a quick look
Re: The Quick/Small/(Stupid?) Question Thread-take 2
Posted: Tue Nov 14, 2017 10:24 pm
how do i get the headrest thing for my seat or is that not possible ?
Re: The Quick/Small/(Stupid?) Question Thread-take 2
Posted: Fri Nov 17, 2017 4:51 pm
What is a "headrest thing"?Lorna c wrote:how do i get the headrest thing for my seat or is that not possible ?
Re: The Quick/Small/(Stupid?) Question Thread-take 2
Posted: Fri Nov 17, 2017 4:52 pm
Here's a real dumb one: Where is the ID number stamp on a U20 block? I see it on a bare R16 but it seems like there is nothing in that same spot on the U20.....
Re: The Quick/Small/(Stupid?) Question Thread-take 2
Posted: Fri Nov 17, 2017 4:54 pm
Might be a replacement block?
Re: The Quick/Small/(Stupid?) Question Thread-take 2
Posted: Fri Nov 17, 2017 4:58 pm
Top surface of the block, adjacent to the #2 cylinder, on the distributor side.tjp wrote:Here's a real dumb one: Where is the ID number stamp on a U20 block? I see it on a bare R16 but it seems like there is nothing in that same spot on the U20.....
Re: The Quick/Small/(Stupid?) Question Thread-take 2
Posted: Fri Nov 17, 2017 4:58 pm
They are stamped just like an R as I recall... same flat place in about the middle of the block at the top edge. If no number, then it probably is a replacement block as Notoptoy said.
Re: The Quick/Small/(Stupid?) Question Thread-take 2
Posted: Fri Nov 17, 2017 5:22 pm
idk isn't there something u can plug into the top of the seat and have it go higher up behind your head ? or is it all seat when some people have higher backs on seats ??tjp wrote:What is a "headrest thing"?Lorna c wrote:how do i get the headrest thing for my seat or is that not possible ?
Re: The Quick/Small/(Stupid?) Question Thread-take 2
Posted: Fri Nov 17, 2017 5:26 pm
i thought mine was too . then i removed my header .. is the R16 under the header kinda by the starter normal because that's where i found numbers on mine if these are the right ones i found .notoptoy wrote:Might be a replacement block?
Re: The Quick/Small/(Stupid?) Question Thread-take 2
Posted: Fri Nov 17, 2017 7:32 pm
OK, yes, that is what I thought. This one is a replacement then since it is blank. thanksJohnnyMac wrote:Top surface of the block, adjacent to the #2 cylinder, on the distributor side.tjp wrote:Here's a real dumb one: Where is the ID number stamp on a U20 block? I see it on a bare R16 but it seems like there is nothing in that same spot on the U20.....
Re: The Quick/Small/(Stupid?) Question Thread-take 2
Posted: Sat Nov 18, 2017 9:13 am
Is the block new? If so it should have the U20, but no numbers. If it has neither, it has been decked.