Page 1 of 1
Midwestern Control Dogbones
Posted: Mon May 09, 2016 6:09 pm
by Jdflyer
I had one of my dogbones snap last week and was on the phone with Midwestern Control to purchase the pieces to make a pair of dogbones. Karen, the rep there, said they are discontinuing the DMCBH-5 ball joint housing used in the wiki. Once their current stock is exhausted they will not be making any more.
Just FYI
Re: Midwestern Control Dogbones
Posted: Tue May 10, 2016 6:05 am
by S Allen
Thanks for the heads up. I will have to update since it will no longer be a viable option.
S
Re: Midwestern Control Dogbones
Posted: Tue May 10, 2016 2:50 pm
by Linda
Is this M5- 0.8 or M5 -.08 for the threaded rod size?
Thx
Linda
Re: Midwestern Control Dogbones
Posted: Tue May 10, 2016 9:37 pm
by Jdflyer
Believe it's 0.8 linda
Re: Midwestern Control Dogbones
Posted: Tue May 10, 2016 10:45 pm
by Linda
OK, then Tech Wiki is wrong, it says M5-.08
Thx
Linda
Re: Midwestern Control Dogbones
Posted: Wed May 11, 2016 5:54 am
by S Allen
Fixed.
S
Re: Midwestern Control Dogbones
Posted: Wed Mar 29, 2017 2:15 pm
by Mainer311
I just tried buying Qty 5 of these for $13.00, and the cheapest shipping option is $20.80 for UPS Ground
Yeah, no thanks.
Re: Midwestern Control Dogbones
Posted: Wed Mar 29, 2017 6:14 pm
by Linda
Too bad they can't use flat rate USPS.
Linda
Re: Midwestern Control Dogbones
Posted: Wed Mar 29, 2017 6:33 pm
by tjp
I needed specific shear pins for my old snow blower. The company wanted well over $10 to ship four pins. I sent an email asking about it and they dropped the shipping cost to a more realistic amount. It never hurts to ask.