Page 1 of 1
Enkei Classic Compe
Posted: Wed Dec 30, 2015 1:00 pm
by andyroo
Just ordered a set of Enkei Compe 15x7 +25 offset in gunmetal. Tires will be Dunlop Direzza DZ102 195/50/15.
I was planning on 10mm front and 15mm rear spacers. Should I go with 15mm spacers front and rear?
I'm eventually planning on the 300zx brakes but don't 100% know if they'll fit. If they don't, I'll probably go with a custom Wilwood set up.
Anyway, I'll post pics when I get the wheels next week! My car is white and I will also be ordering the Smoothline hardtop soon, which I'll have painted gloss black. I'm excited.
Re: Enkei Classic Compe
Posted: Wed Dec 30, 2015 1:33 pm
by andyroo
Also, any recommendations on where to source wheel studs?
Re: Enkei Classic Compe
Posted: Wed Dec 30, 2015 1:58 pm
by spriso
15x7 +25mm should fit over our big brake kit-- you may need a small 3mm spacer, but I bet that they will clear. It will all depend on the back side of the spoke design. It will be interesting to see if the center opening will clear the roadster hub.
Michael
Re: Enkei Classic Compe
Posted: Wed Dec 30, 2015 2:44 pm
by andyroo
Thanks! There is another thread here with someone running these same wheels without a problem from the hub. They went with a ~3mm spacer, I was planning on getting closer to a +15 offset overall with the spacer so I'll likely go with the 10mm front and 15mm rear spacers. I'm guessing I'll be fine with the brakes.
Re: Enkei Classic Compe
Posted: Thu Dec 31, 2015 10:54 pm
by mlwebb
Dave at futofab.com has studs, I used them on mine.
Nice wheels, don't forget pics.
Michael
Re: Enkei Classic Compe
Posted: Thu Dec 31, 2015 11:31 pm
by Alvin
Re: Enkei Classic Compe
Posted: Fri Jan 01, 2016 12:06 am
by fj20spl311
My experience is 15x7 +12 are about the max with those tires. I would suggest 10 mm or less on the rear.
Re: Enkei Classic Compe
Posted: Wed Jan 13, 2016 3:50 pm
by andyroo
Wheels should be at my shop today or tomorrow.
2.125" long studs from futofab are here. Not listed on their website, so you'd have to talk to Dave to get them.
Moroso open ended lug nuts are on their way.
http://www.summitracing.com/parts/mor-46320/overview/
Still need spacers. I found some cheap looking universal 10mm spacers, but I'm not sure I like them. I guess I'm going to have some custom made.
Re: Enkei Classic Compe
Posted: Thu Jan 21, 2016 11:03 am
by andyroo
Got the wheels, extended studs, open ended lug nuts, and the front 10mm spacers. I really like the wheels.
Front spacers were these:
http://www.amazon.com/gp/product/B0069D ... =8-1-fkmr0
Couldn't find 15mm rear slip on spacers so I'll have to have them custom made (unless someone knows of a source). Not in a huge rush as we're about to get a couple feet of snow...
Here are the wheels in my living room where they will sit for a few weeks lol.
