Temperature Sending Unit
Posted: Mon May 12, 2003 12:17 am
Ok folks.......another question. I'm trying to get a reading from my temperature guage on my 68 1600. Grounded the wire running to the guage and it moved just fine so I know the wiring is good as well is the guage. Its a matter of the temperature sending unit. Unfortunatley, I'm not sure how the heck to get it out.
There is a small (8 mm I think) nut that keeps the electrical connecter on (well there is supposed to be) and that part is off no problem. Also notticed there is a 16 mm hollow nut surrounding the sensor......and that comes off ok. However, the temp sending unit won't budge!!!!!!! What am I missing???? (My unit is pretty jacked up.......looks like somebody Oki-rigged what should be the 8 mm with a phillips screw...stipped the little part all up but not sure if thats why the sending unit won't come out) Also....any suggestions on a replacement unit? I think I read somewhere I can use one from a Datusn pickup but I'm not sure. Thanks a lot
There is a small (8 mm I think) nut that keeps the electrical connecter on (well there is supposed to be) and that part is off no problem. Also notticed there is a 16 mm hollow nut surrounding the sensor......and that comes off ok. However, the temp sending unit won't budge!!!!!!! What am I missing???? (My unit is pretty jacked up.......looks like somebody Oki-rigged what should be the 8 mm with a phillips screw...stipped the little part all up but not sure if thats why the sending unit won't come out) Also....any suggestions on a replacement unit? I think I read somewhere I can use one from a Datusn pickup but I'm not sure. Thanks a lot