H20 / H20-II?
Posted: Fri Mar 04, 2005 10:25 am
Anyone know if the H20-II is usable as a stroker motor? The dimensions are all the same, But will the R16 head bolt on?
I have noticed that the H20 uses a head which looks almost identical to the R16, same valves, ports look the same, cast iron, upon first glance looks usable.
The H20-II however has smaller valves, so the head definately cannot be used. But the short-block? anyone know? Would be nice as it has a upgraded plastic/rubber rear main seal.
I have noticed that the H20 uses a head which looks almost identical to the R16, same valves, ports look the same, cast iron, upon first glance looks usable.
The H20-II however has smaller valves, so the head definately cannot be used. But the short-block? anyone know? Would be nice as it has a upgraded plastic/rubber rear main seal.