h25 stroking for good!

steve68 · Post by **steve68** » Wed Feb 23, 2005 3:40 pm

ok, if the pistons have the same compression height, then we can just have the a) drill the piston pin hole in the piston. b) bush the rods.

as im pulling engine out. im plan on using h20 pistons also..

the h25 r16 mix came to 2.2 with standard bore...thats quite a bit of motor.

steve

Post by **spl310** » Wed Feb 23, 2005 4:27 pm

Steve,

If you want to keep the original engine stock, I have a couple of 5 main R blocks here. Cheap too!

Sid

steve68 · Post by **steve68** » Wed Feb 23, 2005 5:00 pm

ill see...have to make sure that the height is the same

steve

DELETED · Post by **DELETED** » Wed Feb 23, 2005 8:05 pm

DELETED

steve68 · Post by **steve68** » Mon Feb 28, 2005 12:14 pm

I didn't think about the bore spacing..thats why the head won't bolt up, but i haven't gotten a 100% answer before even from the fork lift shop

steve

DELETED · Post by **DELETED** » Mon Feb 28, 2005 6:57 pm

DELETED