Datsun Roadster Forum-311s.org

Hey guys,
As you can guess, I was just putting my steering components back together with one of Dean's Urethane Boot Kits. One question for those of you who have used it:

Did you need to smash them down quite a ways to get the cotter pins to go through on the Tie-rods and steering linkage, or is it possible mine are too large?

As always, thanks for the input.

It has been awhile since I put mine on but there should be 10 total I believe. The four bigger ones go on the ball joints. The other six fit on the tie rod ends. I do not recall having to mash anything down as they all fit pretty well. I have a new set for my SR20 conversion frame in a box some where?? Hopefully I will be doing that sooner than later.

Steve