Where is the Jack handle stored?

markjhatch · Post by **markjhatch** » Sat Jun 23, 2012 9:11 am

The jack is pretty obvious (any reason to bundgie strap it down for xcountry trip by car carrier?)

But where does the handle go? Was there a tool wrap at somepoint for the lug wrench and jack handle?

Mark

68DSU · Post by **68DSU** » Sat Jun 23, 2012 9:47 am

The jack should lock in pretty tight in the clips in the trunk. The handle along with a lug wrench, were stowed in a small bag in the general shape of a slice of pie.

Post by **spl310** » Sat Jun 23, 2012 2:21 pm

There were a couple of different tool bags. Earlier bags were rolls iirc, while later bags were rectangular with a single white snap. The later all vinyl ones with the opening on the long side were for later Nissans and Datsuns, but work fine as well. Yes, the handle went in the tool bag. You could leave it on the jack and bungee it in place.

68DSU · Post by **68DSU** » Sat Jun 23, 2012 8:15 pm

Ha, Ha! I dug my bag out of the trunk. It was pie shped because it was rolled up at the bottom and all the wide parts were on the top.
Here are a couple of pictures. I guess the bag kept the Nissan name.

Datsun Roadster Forum-311s.org

Where is the Jack handle stored?

Where is the Jack handle stored?

Re: Where is the Jack handle stored?

Re: Where is the Jack handle stored?

Re: Where is the Jack handle stored?