Page 1 of 1
what works best to glue down frame pads?
Posted: Sat Mar 10, 2012 9:54 am
by roadstermike
I have a reinforced rubber type pad that I am going to use and I've been loking around at all the possibilities of glue or epoxy type products and now I am more confused than when I tarted to look. I thought of using a liquid nails type product but there are 15 to choose from. So I thought it would be easier to ask than experiment. What specific product has anyone used with good results? Appreciate the feedback.
Re: what works best to glue down frame pads?
Posted: Sat Mar 10, 2012 11:00 am
by sports imports
The weight of the body will normally keep it in place.
Ross
sports imports
Re: what works best to glue down frame pads?
Posted: Sat Mar 10, 2012 2:07 pm
by JMartin
I used a 3M spray adhesive. Ross is right that the body should hold it in place. I used about a 1/4" rubber pad instead of the horse hair, and I knew the body was coming on and off a few more times, so I used the 3M spray to hold it in place. I also used it to hold the square body bolt pads to the clip when I bolted down the car. If you are putting new sound deadener inside the car, it works too!