Another new Roadster Owner
Posted: Tue Jan 31, 2012 12:50 am
I am the owner of two red 1967.5 1600 Roadsters. I think I have a whole car between the two. Well almost. I am missing the dash wiring harness, but I am trying to make one. The schematic for the 67.5 does not show the four-way Flasher switch and I have never seen the routing of the wiring harness.
I bought a dash from one of the members here and some others have offered. I just have to figure out what I have and don't. Here is the list. I am putting pictures in the members gallery. I don't know which one to make the parts car though.
Steve
SPL311-11515
1.6L
Weber carbs
5-speed (I think)
Ashtray (any one seen one of these)
PO cut the heck out of the rear compartment seperator, cowl supports, and kick panels.
PO installed a Mustang II radiator on an angle and cut the front frame cross member out.
PO cut the dickens out of the dash.
Rust in the right rear quarter and the right front inner fender torque box.
No dash or engine room wiring harnesses.
A few dents
Hardtop
SPL311-13362
No motor or transmission.
PO started a frame off restoration in 1997
Frame has been cleaned and painted.
Body has rusty floor pans.
The whole body appears to be covered with a coat of bondo.
Soft and hard tops
Partial engine room harness; complete fuse box though.
No dash or dash harness.
New a-arm bushings, ball joint rubbers, frame rubbers, spring bushings...
Radiator.
All the parts that I have were bagged and tagged by the PO. (Thanks)
I bought a dash from one of the members here and some others have offered. I just have to figure out what I have and don't. Here is the list. I am putting pictures in the members gallery. I don't know which one to make the parts car though.
Steve
SPL311-11515
1.6L
Weber carbs
5-speed (I think)
Ashtray (any one seen one of these)
PO cut the heck out of the rear compartment seperator, cowl supports, and kick panels.
PO installed a Mustang II radiator on an angle and cut the front frame cross member out.
PO cut the dickens out of the dash.
Rust in the right rear quarter and the right front inner fender torque box.
No dash or engine room wiring harnesses.
A few dents
Hardtop
SPL311-13362
No motor or transmission.
PO started a frame off restoration in 1997
Frame has been cleaned and painted.
Body has rusty floor pans.
The whole body appears to be covered with a coat of bondo.
Soft and hard tops
Partial engine room harness; complete fuse box though.
No dash or dash harness.
New a-arm bushings, ball joint rubbers, frame rubbers, spring bushings...
Radiator.
All the parts that I have were bagged and tagged by the PO. (Thanks)