Page 1 of 1
Leaf Spring replacment friction pucks
Posted: Tue Dec 07, 2010 2:07 am
by SABLT194
I'm looking for a source for replacement 15/16" diameter pucks that go in between the leaf spring segments. Anyone know of a source for these? If not, I can probably turn some out of urethane bar stock.
Regards,
Steve
Re: Leaf Spring replacment friction pucks
Posted: Tue Dec 07, 2010 3:47 am
by Nissanman
Zactly what I did
Urethane pads.jpg
Easier than trying to find some rubbery bits
Re: Leaf Spring replacment friction pucks
Posted: Sat May 19, 2018 2:41 pm
by ppeters914
DatsunParts.com has them:
http://www.datsunparts.com/2143
NOTE: I bought these, then discovered I have the smaller diameter dimples on my '67 1600 leaf springs. There would be no raised portion to fit into the dimples if I sanded them down as suggested, and I didn't trust them to stay in place with expoxy, so, due to time constraints, I reused the original rubber pieces. Will revisit this later if the old pads become a problem.
BOTTOM LINE: disassemble and measure your dimple diameters before ordering.