Page 1 of 1
Harmonic balacer
Posted: Wed Mar 05, 2003 12:10 pm
by SLOroadster
Does anyone know if the harminic balacer on a U20 is specific to each crank? I found a crack in mine and need to replace it. I have a 2nd one but it is balanced differently from my origanal. I really don't want to have to pull my crank again to balace the thing. I'm wondering because I have the NISMO aluminum flywheel, and I don't think the crank was balaced during the previous rebuild of the engine, and things don't need to be any more out of balace with each other.
-Will
Harmonic balancer
Posted: Wed Mar 05, 2003 3:46 pm
by spl310
Will,
They should all be balanced the same. If you are looking at the drill marks for the balancing, that is not necesarily an indication of how it was balanced. If the outer ring on your original one cracked, it may have walked a bit, so putting it on the balancer will give a different reading than the uncracked one.
Sid
Balance
Posted: Wed Mar 05, 2003 4:31 pm
by TR
Ya, it is typically too expensive for a manufacturer to balance the dampener/crank/flywheel combo. Instead they balance each part individually.
A good speed shop will balance everything.
crack
Posted: Wed Mar 05, 2003 5:17 pm
by SLOroadster
I found the crack on the outside of the key way on the shaft where it fits through the front timeing cover. I have a feeling the crack has been there for a very long time. I'm not going to balace the whole nine yards (against my better judgment) I just want to get the thing out of my friends driveway where it has sat since last July. I think the crank is fairly well balanced as it is, when it was running before it didn't dance around. Im sure it could be better but I wan't to go to Solvang with it in a month.
Will