Datsun Roadster Forum-311s.org

OOPS....but 4.10 was not mine....LOL....should have been 4.1

I was talking ring gear inch size not ratio
The taller the more torque but at high way speed it doesnt have as much ump

I think they are 7"....about 180 mm...smaller than the H190.

Alvin

I can't seem to find your four link in progress pix. Can you re-post?

Vinnyz wrote: Sat Nov 03, 2018 1:13 pm Alvin

I can't seem to find your four link in progress pix. Can you re-post?

Absolutely. I will look for them!

In-progress pics restored (and video!) to page 2

Alvin wrote: Sat Nov 03, 2018 3:34 pm In-progress pics restored (and video!) to page 2

Thanks Alvin. Did you guys happen to make/keep any link and heim dimensional measurements/drawings for the final fitment? ( As in record any?)

Vinnyz wrote: Tue Nov 06, 2018 1:02 am

Alvin wrote: Sat Nov 03, 2018 3:34 pm In-progress pics restored (and video!) to page 2

Thanks Alvin. Did you guys happen to make/keep any link and heim dimensional measurements/drawings for the final fitment? ( As in record any?)

Unfortunately none I can remember. This was ~10 years ago! I plan on removing the assembly to clean things up and make changes if necessary. I can definitely take measurements then.

Forgot to add these pictures with the car on a lift for new tires

Year 12 with the RX-7 rear axle setup!
~57,000 miles on it.





Lots of road grime/dust but still holding up.

That is such a neat and effective suspension set up, I wonder if they could be sold as a kit. Obviously some cutting and welding to install, but it looks like it was made for it.

So, why is inside of your right rear wheel so much cleaner than the left?
That suspension is quite the trick and removing the leaf springs really cleans up the look. I love it!