Wish List for Custom Parts

[DivinDave]

Thanks. Didn't even think to look McMaster. One of the "shoulder screws" should work just fine.

[digits4063]

I believe I have found a supplier for the Carb Bowl Screws referenced in this thread, as well as the hood bolts. They are produced in stainless and, based on my first test fit, the carb bowl screws appear to be correct in size and pitch. On the plus side, a pack of 16 was $5.00 (part number is 9-0410)

They have quite a few connectors and parts for Datsuns and other makes on their site and may be worth checking out.

http://www.mmsacc-stainless.com

[devo]

I would like the bushing that goes on the back side of the steering wheel on my 67. I think the original was 2 piece but they are no longer available.

Do you have a part number or an image of this so I can research further and try to get some specs?

The part number is 48418-30800. In the service manual, it's called collar - steering wheel fixing. In the picture it's part 14.

Don't know if you found this steering wheel bushing yet. Here is one on eBay. Same part as earlier years.

http://www.ebay.com/itm/Datsun-Roadster ... d8&vxp=mtr