Datsun Roadster Forum-311s.org

made the clips as new with new rubbers



did some spaghetti work today, first 50mtr wiring is in the front...it fit's nice in the X-brace...

more wiring and nozzle fluid pipes...

outside left wheel





inside enginebay



looking good...

That angle though.

What a great build you have there! Keep up the great work, hope you get her started before new Year. If you do send a video!

Good luck, take care.

Maybe we can try to fire it up when the body is out to the paintshop. First another fender and 2 doors to go...
But will not happen this year anymore.

Did some wiring and replumbing on the fuellines and waterpipes. Also puzzled with the starter. You can remove it (when the waterpipes are relocated) without removel of the triangler plate at the rightside of the body. But my husband already made another triangler plate for more access and when you grow older and don't have the handy tools and Japanese finger skills anymore, a removable plate will be handy. (we can make it now and don't want to cut and weld later after painting). WE WHERE GLAD WE MADE IT WITH WIRING INSTALLING IT CAME IN VERY HANDY

new wiring rightside for turnsignal, fan, watertempsensor, oilpressure sensor, alternator controllight



underneath airvalve readjusted the fuellines, better picture later



love my washerfluidbottle



want to make a groundpoint on the body on bothsides for the negative groundwires



wires for beamlights in front of the grille (don't want them but you never know)



the length is a bit to long, but the new wires have to go thru the side (next to antenna) inside the car



Also washer fluidline goes along with the leadingwire and instead of going thru the inside it goes thru the water outlet (above the hole of the antenna), don't forget to plug of the hole which was originally used for the fluidline underneath the air intake in front of the windshield



almost removed all the clips



new wiring in trunk for rear- and turninglights, backuplights, licenseplatelight, fuelpump and fuelpumplevel indicator

Where you going to mount the battery?

@Ed in the trunk at the rightside

removed some polyester out the trunk
my hubby made a removable triangle plate
releade heaterhoses and fuelpipes

Another day with cleaning trunk area and engineroom, pffff
maybe newyearsday some epoxy primer









gound point on rightside (make one at the leftside too but that will be in the inner fender)



made a bigger hole for the new engine wiring

5.5 hours to go for a new Happy Roadstering year

I like the removable plate for starter access (assuming its on that side... I didn't look!). They make restorations/modifications look sooooo easy on TV... But you guys know just how much time, effort, patience and focus it takes. It's great that you and your husband are doing this together without you wanting to rivet him to the shop wall! Teamwork baby! Well done...

Thanks Greg, we are petrolheads so the shoppingmall is not our favorit place to spend time

today cleaning engine bay and painted the interior side black

















groundingpoint



and at the left side

new schedule dashboard wiring

engine bay area almost clean











the rear plate was cracked/lose from the trunkbottom (after removing the polyester)
welded again

getting there...