Datsun Roadster Forum-311s.org

Zzzt zzzt

Last body mount, park brake quadrant, and seat straps done!!

Nice!

OH man, I went back a few pages to see whats going on here... Looks like I will start at page one tomorrow. I love fresh metal! My old 77 Phoenix Red Rabbit was noticeably happier when we removed the license plates that were used as a floor and welded in the freshly stamped floor piece.

Love it! Keep it up zzzt zzzzt zzzzzzt haha

Watching paint dry Time to do some inventory accountability on the flat dash components

Hey David, I have some decent used toggle switches if you are in need. Pat

Pat, will definitely have questions as to where which one goes where.
.
Extra piece of Sports Imports floor pan. Worked out well. Will fab the forward section in two pieces.
.
.

Man, the Upol copper rich weld thru primer smells like candy! But at $38 one coat is all its getting.
Hope the fender fits.
.
.

Nice looking repair David.

theunz wrote: Sat Feb 02, 2019 9:59 pm Nice looking repair David.

Thanks Mike, took about 4 days eeek! Only caught my clothes on fire once.

David, you're retired now, 4 days sounds like your working way to hard!
It's winter, if you don't set your clothes on fire when welding your going to freeze to death.

With the high cost of respirator cartridges, i like to get as much done as I can before they expire. About ten days for non paint use. Will try and repair the pass side next week

Well this def complicates things.
.
.

pebbles wrote: Mon Feb 11, 2019 9:32 pm Well this def complicates things.
.
0E44C1C0-42B3-4513-9279-61F58C70C22C.jpeg
.

Time to bust out the cardboard design! Car will be so fresh and ready for the snow when you're done.

pebbles wrote: Mon Feb 11, 2019 9:32 pm Well this def complicates things.
.
0E44C1C0-42B3-4513-9279-61F58C70C22C.jpeg
.

OMG. Bound to be another years delay!


Ted