Re: New club forming?
Posted: Mon Aug 11, 2008 12:09 pm
I don't usually post 'hey there' type posts, but I am just getting back to my project after it sitting since 2001 and wanted to share. When I first registered I was under the username (DCG_Racing).
I spent a year out in Oregon and then bought a 'new' racecar which stole my time away from my roadster project for the last few years. I have since sold the racecar and am now able to dedicate a little more time to the project.
When I left the project in 01, I just had taken the head off and replaced the head and manifold gaskets. All that remains to see if this thing runs again is to finish putting the carbs back on (hope I am able to figure out where all the vacuum lines and cables go) and drain / fill the gas tank up.
Before I did the work above, it was running pretty hot so I'll see if the new head gasket help quell that problem. If it starts and runs, I'll likely need a new radiator (or re-core), new brakes, and a new clutch for starters.
For anyone in St. Louis, I live in Ofallon (MO) and work in Chesterfield. I'd be up for a lunch if you are in the area.
Best,
Mike
I spent a year out in Oregon and then bought a 'new' racecar which stole my time away from my roadster project for the last few years. I have since sold the racecar and am now able to dedicate a little more time to the project.
When I left the project in 01, I just had taken the head off and replaced the head and manifold gaskets. All that remains to see if this thing runs again is to finish putting the carbs back on (hope I am able to figure out where all the vacuum lines and cables go) and drain / fill the gas tank up.
Before I did the work above, it was running pretty hot so I'll see if the new head gasket help quell that problem. If it starts and runs, I'll likely need a new radiator (or re-core), new brakes, and a new clutch for starters.
For anyone in St. Louis, I live in Ofallon (MO) and work in Chesterfield. I'd be up for a lunch if you are in the area.
Best,
Mike