The Resource For All Things Datsun Roadster S211/SPL212/310/311 Datsun Sports Roadster 1959-April 1970 circa 40,000 produced
https://www.311s.org/phpBB3/
Keep us updated, what are you starting with?AltxF4 wrote: Wed Apr 29, 2020 9:59 pm I think this is going to be fun! Once I get a block for mock up, we will see what direction this takes. Either ITBS with Holley or MS ECU, or two small turbskies K03 or the likes. With the Holly ECU, I know I can implement TC with the use of wheel speed sensors. Rear end will probably be an 8" with Torsen LSD.
It will be several months before I can get the engine and trans.
Starting with a 66, minimal rust, but still some rotted out spots none the less. The more I keep seeing this motor in other cars, the more I love the idea!Alvin wrote: Thu Apr 30, 2020 9:06 pmKeep us updated, what are you starting with?AltxF4 wrote: Wed Apr 29, 2020 9:59 pm I think this is going to be fun! Once I get a block for mock up, we will see what direction this takes. Either ITBS with Holley or MS ECU, or two small turbskies K03 or the likes. With the Holly ECU, I know I can implement TC with the use of wheel speed sensors. Rear end will probably be an 8" with Torsen LSD.
It will be several months before I can get the engine and trans.
Um.. I think there is a sticky at the top of this section. Have you read it?redroadster wrote: Thu Apr 30, 2020 6:39 pm I want to clip the wings and elevator on my 2000hp p47
It's my plane I should be able to do it
What could go wrong ?
More on the way!AltxF4 wrote: Fri May 01, 2020 4:51 pmStarting with a 66, minimal rust, but still some rotted out spots none the less. The more I keep seeing this motor in other cars, the more I love the idea!Alvin wrote: Thu Apr 30, 2020 9:06 pmKeep us updated, what are you starting with?AltxF4 wrote: Wed Apr 29, 2020 9:59 pm I think this is going to be fun! Once I get a block for mock up, we will see what direction this takes. Either ITBS with Holley or MS ECU, or two small turbskies K03 or the likes. With the Holly ECU, I know I can implement TC with the use of wheel speed sensors. Rear end will probably be an 8" with Torsen LSD.
It will be several months before I can get the engine and trans.
Actually, the point is to avoid people getting in angry back and forth messages, and destroying the forum. I would encourage the mods to look at ALL of your posts in this section of the forum, and decide if you are following the spirit of the rules..redroadster wrote: Sat May 02, 2020 8:31 am Ha ha... thats ironic / funny , your a stickler for minor laws on this topic
+1RCMike wrote: Sat May 02, 2020 5:56 pmActually, the point is to avoid people getting in angry back and forth messages, and destroying the forum. I would encourage the mods to look at ALL of your posts in this section of the forum, and decide if you are following the spirit of the rules..redroadster wrote: Sat May 02, 2020 8:31 am Ha ha... thats ironic / funny , your a stickler for minor laws on this topic