BRAKE LINE LEAK

Jorge022770 · Post by **Jorge022770** » Sat Sep 17, 2005 12:48 am

Dave:

First of all, thanks for your always helpful input!

Now, how did you free the piston when this happened to you?

Jorge

Post by **dbrick** » Sat Sep 17, 2005 12:33 pm

Just took it apart, piston was stuck in bottom of bore, so used a little force, put pile of rags on the bench and slammed master cyl down on to it until it came free. There is a spring and a ball ended rod between the two piston halves. The ball/socket is what bound up Just cleaned everything, wiggled and twisted to make sure it wouldn't bind and put it back together.

So far is working.

Jorge022770 · Post by **Jorge022770** » Tue Sep 20, 2005 8:05 am

Dave:

My symptoms are exactly the same u described happened to you and to Joaquin....I guess I will take the whole thing apart this weekend then.

Now, I read someone's posting talking about some chemical I should use to flush clean the lines...what is it?

And am I supposed to do anything else (besides bleeding them) to the front calipers and rear cylinders?

Jorge

Post by **dbrick** » Tue Sep 20, 2005 10:19 pm

I've heard of flushing with alcohol, I don't know what type, denatured is my guess, before changing to DOT 5 silicone fluid. You can also just flush it with clean brake fluid. One advantage of silicone is it supposedly won't harm paint as badly as standard fluid, but I never tried it myself.

Also, don't use anything except brake fluid or brake cleaner on the hydraulics, anything with petrolium base, WD40 etc will destroy the rubber seals. If you need to use it, remove the rubber parts, then flush with brake cleaner thoroughly before reassembly.

I'm ordering a master cyl this week, tired of screwing around.